Resources

Edge banding: how to plan and apply it

The raw edges of plywood, MDF and particleboard look unfinished and soak up moisture. Edge banding closes them. Plan it while you make your cut list, and you buy the right amount and know which edges really need it.

In short: Banding should be a little wider than the sheet is thick; for ¾ in plywood, 7/8 in banding is common. For the quantity, add up the lengths of all banded edges plus about an inch per edge. Iron-on banding goes on with a clothes iron without steam.

CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →

White melamine shelf with freshly ironed-on edge banding, rolls of white and oak banding, a utility knife and a sanding block
Illustration, computer-generated

Types of edge banding

TypeTypical thicknessHow it goes onGood for
Iron-on wood veneerunder 1/32 inpre-glued, applied with an ironhardwood plywood shelves and cases
Iron-on melamine / PVCunder 1/32 inpre-glued, applied with an ironmelamine particleboard, closet shelves
Thick PVC / ABSup to about 1/16 incontact cement or an edgebanderkitchens, heavy-use edges
Solid wood edging1/4 in and upglued on, then planed or sanded flushshelves, tabletops, show edges

Width and quantity

Banding should be a little wider than the sheet is thick, so you can trim the overhang afterwards. For ¾ in plywood, 7/8 in wide banding is common. Check what your supplier carries.

For the quantity, add up the edge lengths of all parts that get banding, plus about an inch per edge for trimming the ends. In the planner, open “More settings” on a part and choose how many edges along its length and width get banding. The result then shows the total feet per material group, with 1 in extra per edge.

Ironing on edge banding

  1. Make the edge clean and free of dust. Fill tear-out first.
  2. Lay the banding on with some overhang at both ends, glue side to the panel.
  3. Move a dry iron (no steam) slowly along the banding until the glue melts. Use the temperature given on the package.
  4. Press it down right away with a wood block or a J-roller and let it cool.
  5. Trim the ends and the overhang on both faces with an edge trimmer, a sharp utility knife or a file.
  6. Ease the edges lightly with fine sandpaper so they do not lift.

Order and cut size

  • If a part gets several edges, band the less visible ones first and the show edge last, so the visible banding covers the joints.
  • Thin iron-on banding hardly changes the size. With thick PVC or solid wood edging, subtract its thickness from the cut size when the finished size must be exact.
  • The planner treats parts as finished sizes and subtracts nothing for banding. Enter the size you cut the sheet to.
  • Band edges before assembly where you can. Inside edges of a finished cabinet are hard to reach.

Start planning