Resources

Store and use your offcuts

Every cutting job leaves offcuts. Stored well and labeled, they become stock for the next project. Stored badly, they warp, get in the way and end up in the trash anyway.

In short: Keep offcuts that can still yield a useful part, store sheets on edge sorted by material and thickness, and label each piece with material, thickness and size. In the planner, enter offcuts as “Existing offcut”; strips under about 2 in wide count as waste.

CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →

Offcut storage in a shop: sheet offcuts sorted by material in vertical bins, lumber on wall brackets and a crate of short pieces
Illustration, computer-generated

What is worth keeping?

  • Sheet offcuts that can still yield a useful part, such as a shelf, a drawer side or a template.
  • Lumber offcuts longer than the shortest parts you usually need.
  • Narrow strips and tiny pieces only if you have a specific use. That is why the planner lists offcuts under about 2 in wide as waste.

Store them properly

  • Sheet offcuts upright in bins, separated by material and thickness. You see everything at once and pull out a piece without restacking.
  • Long boards flat on wall brackets with several supports, so they do not sag.
  • Short pieces in a crate by species.
  • Keep them dry and off a cold concrete floor. MDF and particleboard swell with moisture.

Labels save measuring

A strip of masking tape with material, thickness and size, such as “¾ ply · 24 × 13½”, saves measuring and guessing. On veneered offcuts, add an arrow for the grain direction.

Plan offcuts in the planner

  1. Enter an offcut as its own stock and tick “Existing offcut” under “More settings”. The planner uses such pieces first.
  2. Choose “Keep the largest possible offcut” as the optimization goal if the new plan should again leave a useful piece.
  3. With Pro, the offcut library keeps the usable offcuts of a cutting plan in your browser. In your next project, add them as stock with one click.

Clear out regularly

Look through your offcuts before every larger project. What you have not used in a year often stays unused. Small pieces still make good test pieces for finish, glue and saw settings.

Start planning