TERMS IN BRIEF
Glossary: cutting and materials
The key terms around cutting, materials and cutting plans, each explained in two or three sentences. Every term links to a guide or resource with more detail.
- Crosscut
- A cut across a board, bar or tube that brings it to a set length. When you only cut to length and width and thickness stay the same, linear cutting (1D) is all you need. Read more →
- Stock
- The material you cut from: full sheets, boards, bars or offcuts you already have. In the planner you enter stock with its size and the quantity available; identical pieces share one row. Read more →
- Trim cut
- A narrow cut along the edge of a sheet that removes dinged or rough factory edges and gives a straight reference edge. About ⅛ to ¼ in per side is common; the planner removes the trim before placing parts. Read more →
- Grain direction
- The direction in which the wood grain or decor runs. When parts must match, such as doors and drawer fronts, rotation is locked so the grain runs the same way on every part. Read more →
- Guillotine cut
- A straight cut that splits a piece completely from one edge to the other. Panel saws, table saws and store cutting services work this way, so the planner only produces plans made of such cuts. Read more →
- Edge banding
- A strip of veneer, plastic or solid wood that covers visible sheet edges. It is sold by the foot or roll; each edge needs a small allowance for trimming the overhang at both ends. Read more →
- Cabinet box (carcass)
- The basic box of a cabinet or bookshelf: sides, top, bottom and usually a back. Depending on the construction either the sides or the top and bottom run through; the parts that sit between them are two thicknesses shorter. Read more →
- Yield (material utilization)
- The share of the stock area or length that ends up in finished parts. The rest is kerf, trim cuts and offcuts; a high yield means little waste. Read more →
- Nominal vs. actual size
- The nominal size is the name on the label, the actual size is what you measure. A 2×4 measures 1½ × 3½ in and ¾ in plywood is often 23/32 in; always plan with the measured size. Read more →
- Sheet goods
- Engineered wood sold in sheets, such as plywood, MDF, particle board, melamine and OSB. They come in large sizes, usually 4 × 8 ft, and are divided into rectangular parts with sheet cutting (2D). Read more →
- Offcut
- A usable piece left over after cutting. Offcuts can be entered as stock for the next project; very narrow strips under about 2 in are listed as waste in the planner. Read more →
- Kerf
- The width of material the saw blade removes with each cut, typically ⅛ in. It is lost on every cut and must be planned for, or the last parts will not fit on the sheet. Read more →
- Cutting sequence
- The order in which the cuts are made. With guillotine cuts you first cut strips and then divide them further; the planner numbers every cut with its position and size. Read more →
- Waste
- Material that does not end up in parts: kerf, trim cuts and leftovers too small to use. A good layout, suitable stock sizes and reusing offcuts all reduce waste. Read more →
- Cut list
- The list of every part you need, with size, quantity and label. From it and your stock the planner computes the cutting plan; a short version is made for store cutting services. Read more →