Resources
How much material to buy: planning for waste
The total area of your parts is the minimum, not your shopping list. Between the cut list and the receipt are saw kerfs, trim cuts, grain rules and defects in the wood. A cutting plan gets you closer than any rule of thumb.
In short: The total area of your parts is only the minimum. A cutting plan with your store’s stock sizes shows how many sheets or boards of each size you really need, after kerfs, trim cuts and grain rules. For solid lumber, buy one extra board in case a defect shows up.
Updated November 11, 2026 · CuttingFox team
CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →

Where material goes
- Kerf: every cut removes the width of the blade, typically 3/32 to ⅛ in.
- Trim cuts: ragged factory edges are cut straight first.
- Grain direction: parts that cannot rotate leave more strips behind.
- Defects: knots, splits and shipping damage make some areas unusable.
- Mistakes: a mismeasured part has to be cut again.
The rule of thumb and its limits
For simple sheet-good projects, an allowance of 10 to 15 % on top of the part area is often suggested; for solid lumber with defects, more. That is fine for a first estimate. How many sheets or boards you need, though, depends on how parts fit the stock sizes. Two 50 in parts simply do not fit on one 8 ft board.
Shopping with the planner
- Enter every part with size, quantity and label.
- Add the stock sizes your store carries and turn on “Plan extra material”.
- Set your blade’s kerf and, if needed, an edge trim.
- Calculate. The summary shows how many sheets or boards of each size you need.
- For solid lumber, buy one extra board in case a defect shows up while cutting.
Offcuts count
Already have leftovers in the shop? Enter them as separate stock rows. The planner uses them first when they fit, so you only buy what is actually missing.