Help
Reading a cutting plan: sequence and guillotine cuts
A plan is only as good as its execution at the saw. That is why CuttingFox describes every cut as a concrete work step.
In short: The cutting sequence lists every cut in the order you make it: which piece, where to measure and what is left. All cuts are straight and run all the way through (guillotine cuts), so a table saw, panel saw or track saw can make them. You measure from the left or top edge of the current piece.
Updated November 15, 2026 · CuttingFox team
CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →
What are guillotine cuts?
A guillotine cut runs straight through an existing rectangle from edge to edge and splits it into two rectangles. Each following cut splits one of those pieces again. The result is a cutting tree you can work through on a table saw, panel saw or with a track saw.
Freely nested layouts may show slightly less waste on paper but often cannot be made with straight through cuts. CuttingFox therefore only produces saw-ready guillotine plans.
The cutting sequence step by step
Under “Cutting sequence” every cut is listed in the order you make it, for example:
- Cut 1 · Piece 96 × 48 in: horizontal cut 12 in from the top edge. Leaves 96 × 12 in and 96 × 35 7/8 in; kerf 1/8 in.
- Cut 2 · Piece 96 × 12 in: vertical cut 40 in from the left edge. Leaves 40 × 12 in and 55 7/8 × 12 in.
Choosing the direction of the first cut
For sheets, “First cut on each sheet” sets how the first through cut after edge trimming runs: “Rip” along the length (horizontal in the drawing) or “Crosscut” along the width (vertical). This helps when you want to rip strips on the table saw first, or break down a large sheet across first so it is easier to handle. Cut 1 on every sheet then runs in that direction, after that the optimizer plans freely. With “Automatic” (the default) the planner tries both directions and keeps the better one.
Where to measure from
“From the left edge” and “from the top edge” refer to the current intermediate piece as drawn. The dimension is the width of the piece being cut off; the kerf lies on the remaining side. Set your fence to the part dimension and cut on the waste side of the line.
Click a cut in the list to highlight and number it in the drawing. Click again to show all cuts.
Edge trim comes first
If you set an edge trim, these trimming cuts appear as T1, T2 … before the main sequence. The separating cuts for your parts follow afterwards.
Linear plans
In linear mode a step reads, for example, “Piece 96 in: cut at 44 in from the start. Leaves 44 in and 51 7/8 in”. Work through the cuts of one bar in the order given and every length, kerf included, comes out right.