Example · Sheet cutting

Grain-matched decorative panel

Doors and drawer fronts from a veneered panel whose grain must run lengthwise. Rotation is locked so every front matches.

Open and edit in the planner

Free · No sign-up needed · Your data stays with you

Stock piece 1 / 1
Veneered panel 1 · 80 × 40 in1 · Door →36 × 161 · Door →36 × 1636 × 7 3/42 →24 × 162 →24 × 1624 × 7 3/419 3/4 × 4080 in →40 in

Result

  • 4 / 4 Parts placed
  • 1 Stock piece
  • 6 cuts
  • 60.0 % Material use
  • 0.17 ft² Saw loss
  • 19 3/4 × 40 in largest offcut

✓ Geometry independently validated

Your stock

  • Veneered panel: 1 × 80 × 40 in · Available stock

Parts to cut

  • Door: 2 × 36 × 16 in
  • Drawer front: 2 × 24 × 16 in

Rules

  • Material group: Lengthwise grain · 5/8 in
  • Saw kerf: 1/8 in
  • Edge trim: 0 in
  • Grain axis: Along length →
  • Allow 90° rotation: no

Cutting sequence · Stock piece 1

  1. Piece 80 × 40 in: vertical cut 36 in from the left edge. Leaves 36 × 40 in and 43 7/8 × 40 in; kerf 1/8 in.
  2. Piece 36 × 40 in: horizontal cut 16 in from the top edge. Leaves 36 × 16 in and 36 × 23 7/8 in; kerf 1/8 in.
  3. Piece 36 × 23 7/8 in: horizontal cut 16 in from the top edge. Leaves 36 × 16 in and 36 × 7 3/4 in; kerf 1/8 in.
  4. Piece 43 7/8 × 40 in: vertical cut 24 in from the left edge. Leaves 24 × 40 in and 19 3/4 × 40 in; kerf 1/8 in.
  5. Piece 24 × 40 in: horizontal cut 16 in from the top edge. Leaves 24 × 16 in and 24 × 23 7/8 in; kerf 1/8 in.
  6. Piece 24 × 23 7/8 in: horizontal cut 16 in from the top edge. Leaves 24 × 16 in and 24 × 7 3/4 in; kerf 1/8 in.

Sheet cutting optimizer →