Resources

Track saw, table saw or miter saw? Choosing the right saw

Even the best cutting plan falls short if the saw does not suit the cut. Full sheets, narrow strips and short boards call for different tools, and each saw has its own kerf that belongs in the plan.

In short: Break down full sheets with a track saw, rip narrow strips and repeated widths on the table saw, and cut boards to length on a miter saw. Each saw has its own kerf, typically about 3/32 to ⅛ in. Measure it with a test cut and enter it in the plan.

CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →

Track saw on a guide rail over a sheet, next to a miter saw with a board
Illustration, computer-generated

The saws at a glance

SawBest forTypical kerf
Track sawfull sheets, straight rips and crosscutsabout 3/32 in
Table sawnarrow strips, repeated widths⅛ in full kerf, 3/32 in thin kerf
Miter sawcutting boards to length, mitersabout 3/32 to ⅛ in
Circular saw with a straightedgerough breakdown, job siteabout 3/32 to ⅛ in
Jigsawcurves and cutouts, not precise sizingthin but wanders

Finding your actual kerf

The values above are rough guides. Your blade decides: the kerf is usually printed on it. For better accuracy, make a test cut in scrap and measure the slot with calipers. Enter that value as the kerf in the planner; ⅛ in is a sensible default for a full-kerf blade.

Tools and cutting sequence

  • With a track saw or table saw you rip sheets into strips and crosscut the strips into parts. The planner creates edge-to-edge cuts for exactly that.
  • Break full 4 × 8 sheets down with a track saw or circular saw first, then size the pieces on the table saw.
  • For many boards of the same length, set a stop block on the miter saw.

Cutting aluminum extrusion and metal tube

Aluminum extrusion such as 1.5 in T-slot cuts cleanly on a miter saw fitted with a blade made for non-ferrous metal, which has a negative hook angle. A wood blade is not meant for it. Check your saw’s manual to see whether it is approved for aluminum. Clamp the profile, feed slowly and deburr the cut end. Such blades usually cut a kerf of about ⅛ in; measure it as described above.

For steel tube, a cold saw, a metal-cutting band saw or an abrasive chop saw suits better than a wood saw. Many suppliers also cut T-slot to length. If you buy full bars, plan the lengths in the planner’s linear mode.

Safety

Use sharp blades, the riving knife and dust collection, wear hearing and eye protection and follow your saw’s manual. Always use a push stick for narrow rips on the table saw.

Start planning