Free · Lumber & tubing

Linear cutting optimizer

Lumber, trim, tubing and profiles with a fixed cross section: CuttingFox spreads the lengths you need across the boards and bars you have and shows what remains.

Free · No sign-up needed · Your data stays with you

Example · Lumber shelf frame10 / 10 parts
2×4 stud, 8 ft 1 · 96 in1 · Upright441 · Upright447 3/496 in
✓ Geometry independently validated10 cuts

How to plan your linear cuts

  1. Enter stock lengths and quantities, for example 4 boards of 8 ft.
  2. Check the kerf of your saw, optionally an end trim at start and end.
  3. Add the lengths you need with quantity and label.
  4. Put different cross sections into separate material groups.
  5. Press “Calculate cutting plan” and follow the cuts per bar.

What you enter

InputMeaning
Lengthstock length or length of the required part
Store sizefills in common lengths such as 8, 10 or 12 ft with one click
Quantitybars available or parts required
Kerfmaterial each separating cut removes
End trimrough ends cut off first
Material groupkeeps profiles or cross sections apart
Price per pieceoptional, for the material cost per part

What the cutting plan shows

  • every bar as a scaled strip with all parts
  • cutting steps in order, measured from the start
  • remaining length and saw loss per material group
  • usable offcuts and narrow waste pieces
  • unassigned parts with a reason

A deterministic heuristic compares several cutting strategies, and an independent validator checks every result for overlaps, dimensions, quantities and material balance. Global optimality is not promised.

Tips for less waste

  • List every length you have, including short offcuts.
  • A board that is only shortened belongs in this mode.
  • For mitered tubes, determine the length at the longest edge first; miters are not calculated.

Reduce waste: 8 tips for better cutting plans →

Frequently asked questions

Can I mix several stock lengths?

Yes. Enter every length you have as its own row with its quantity. The calculation uses them together.

Is the kerf deducted for every part?

Only for real separating cuts. A part exactly as long as the bar loses nothing.

Does it work for metal tubes and profiles?

Yes, for any material with a fixed cross section that is only cut to length. Different profiles belong in separate material groups.

Can I enter lengths in inches?

Yes, in inches or feet, including fractions such as 23 3/8.