Help
Account for saw kerf correctly
Every saw cut removes material. Forget the kerf and you end up with a part a fraction of an inch short. Here is how CuttingFox accounts for it.
In short: Kerf is the strip of material the blade removes, and it sits between every two parts: two 24 in parts with a 1/8 in kerf need 48 1/8 in, so they do not fit in 48 in. Measure your blade’s kerf with a test cut and enter it in the planner.
Updated November 11, 2026 · CuttingFox team
CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →
What is kerf?
Kerf is the strip of material the blade removes. It is usually slightly wider than the blade body because the teeth are set or ground wider.
The value depends on your saw and blade. Do not trust a preset: measure the tooth width with calipers or make a test cut and measure the slot.
A worked example
| Stock | Parts | Kerf | Result |
|---|---|---|---|
| 48 in | 2 × 24 in | 1/8 in | does not fit: 24 + 1/8 + 24 = 48 1/8 in |
| 48 1/8 in | 2 × 24 in | 1/8 in | fits exactly, 0 in left |
| 48 in | 1 × 48 in | 1/8 in | fits without a separating cut |
| 48 in | 1 × 20 in | 1/8 in | one cut, 27 7/8 in left |
CuttingFox only counts kerf for separating cuts that are actually made. An existing outer edge needs no cut, so a part exactly as long as the stock loses nothing.
Narrow end slivers
If less material than one kerf remains after a cut, only the material that is still there counts as loss. The plan never shows negative remaining lengths or “usable” offcuts only a hair wide.
Edge trim is something else
Edge trim sacrifices damaged or rough edges before parts are cut. Enter the full edge that is lost, including the kerf of that trimming cut. In sheet mode all four sides can be set separately.
Different saws, different groups
If you cut lumber on a miter saw and sheets with a track saw, create two material groups. Each group has its own kerf.