Example · Sheet cutting

Offcuts and limited stock

Tight stock: one sheet and an existing offcut. The example shows how offcuts are used and what happens when it gets tight.

Open and edit in the planner

Free · No sign-up needed · Your data stays with you

Stock piece 1 / 2
Offcut 1 · 28 × 20 in1 · Back panel26 × 1826 × 1 7/828 in20 in
Stock piece 2 / 2
Sheet 48 × 24 1 · 48 × 24 in2 · Side piece22 × 102 · Side piece22 × 1022 × 3 3/42 · Side piece22 × 102 · Side piece22 × 1022 × 3 3/448 in24 in

Result

  • 5 / 5 Parts placed
  • 2 Stock pieces
  • 8 cuts
  • 78.7 % Material use
  • 0.16 ft² Saw loss
  • 3 3/4 × 24 in largest offcut

✓ Geometry independently validated

Your stock

  • Sheet 48 × 24: 1 × 48 × 24 in · Available stock
  • Offcut: 1 × 28 × 20 in · Existing offcut

Parts to cut

  • Back panel: 1 × 26 × 18 in
  • Side piece: 4 × 22 × 10 in

Rules

  • Material group: Plywood · 1/2 in
  • Saw kerf: 1/8 in
  • Edge trim: 0 in
  • Grain axis: No constraint
  • Allow 90° rotation: yes

Cutting sequence · Stock piece 1

  1. Piece 28 × 20 in: vertical cut 26 in from the left edge. Leaves 26 × 20 in and 1 7/8 × 20 in; kerf 1/8 in.
  2. Piece 26 × 20 in: horizontal cut 18 in from the top edge. Leaves 26 × 18 in and 26 × 1 7/8 in; kerf 1/8 in.

Sheet cutting optimizer →