Help
Use offcuts and limited stock
Most workshops have offcuts on the shelf. CuttingFox plans with exactly the material you enter and tells you plainly when it is not enough.
In short: Enter offcuts as their own rows with their real size, in the same material group as the parts, and mark them as “Existing offcut”. The planner only uses the stock you enter and shows which parts are missing and why. It plans extra material only when you allow it.
Updated November 11, 2026 · CuttingFox team
CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →
Enter offcuts as stock
- Add the offcut as an extra row under “Your stock” with its real dimensions.
- Mark it as “Existing offcut” under “More settings”.
- Check the material group: the offcut must be in the same group as the parts it may be used for.
A piece of the same size but different thickness is not a substitute, so parts are never assigned to another material group.
Use only the stock you have
By default the plan only uses the quantities you entered. Parts that no longer fit are listed with a reason: no matching material, dimensions do not fit or stock is insufficient.
The calculation is a deterministic heuristic. It compares several strategies but may, in rare cases, miss a feasible combination. An unplaced part is a strong hint, not a mathematical proof that it is impossible.
Purchase suggestions only on request
If you enable “Plan additional stock”, the plan may suggest more pieces of the sizes you entered. These are marked as purchase suggestions in the result and PDF, never as existing stock.
Spot usable offcuts
After calculating, the plan lists all remaining rectangles and lengths, largest first. Pieces large enough to reuse are marked “Usable offcut”, very narrow strips “Narrow waste”. Add usable offcuts back as stock after cutting.
Material use in percent and offcut size are different measures: one large connected offcut is often worth more than a few extra percent of utilisation.