Help
Grain direction and rotation in sheet cutting
With veneer, solid wood and many decorative panels the grain should run the same way on every part. CuttingFox lets you set this per sheet and part, and an allowed rotation can never override it.
In short: Set the same grain axis on the sheet and the part, and the grain runs the same way on every part; an allowed 90° rotation never overrides it. Only materials with visible grain such as solid wood, veneer or wood-look panels need a rule, because every rule can cost material.
Updated November 11, 2026 · CuttingFox team
CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →
Length and width keep the meaning you enter
The app does not swap length and width just because one side is longer. A part’s length runs horizontally along the X axis in the drawing, its width vertically along the Y axis.
Allowing rotation
Without a grain constraint a part may be placed rotated by 90 degrees when “Allow 90° rotation” is on. This often improves material use. Rotated parts are marked “90°” in the parts list.
Setting a grain direction
- Open “More settings” on the sheet and choose the grain axis, for example “Along length →”.
- Choose the same axis on every part that should follow the grain.
- Calculate. Parts with a grain constraint are only placed where part and sheet axes match.
Arrows in the drawing show the grain on sheet and part. A locked grain cannot be bypassed by an allowed rotation; if in doubt a part stays unplaced and is listed with a reason.
Which materials need a constraint?
Only enter the direction your material really requires. Every constraint limits placement and can cost material.
- Solid wood and edge-glued panels: usually yes; the grain is visible and affects stability.
- Veneered and woodgrain decor panels: yes, if fronts should match.
- Plain MDF and solid-color panels: usually no; there is no natural grain.