Help

1D or 2D: linear cutting or sheet cutting?

CuttingFox has two modes. The right one depends less on the material than on how you cut it: only to length, or across the width as well.

In short: If you only cut to length, as with 2×4s, trim, tubing or profiles, use linear mode (1D). If you also cut across the width, as with plywood, MDF or boards you rip, use sheet mode (2D).

CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →

Linear cutting (1D)

In linear mode every stock piece has a fixed cross section and you only cut it into shorter lengths. Typical uses are studs, furring strips, baseboards, steel and aluminum tubing, threaded rods and profiles.

Enter the stock lengths and quantities, then the lengths you need. The result shows per bar which parts are cut in which order and how much length remains.

2×4 stud, 8 ft 1 · 96 in1 · Upright441 · Upright447 3/496 in
Linear cutting (1D): every board is only cut to length.

Sheet cutting (2D)

In sheet mode stock and parts have two dimensions: length and width. This covers plywood, MDF, particle board, laminated panels and boards that you also rip lengthwise.

The plan consists of straight, full-length cuts through an existing rectangle. These guillotine cuts can be made on a table saw, panel saw or with a track saw.

Plywood sheet 4×8 1 · 96 × 48 in1 · Side panel40 × 121 · Side panel40 × 122 · Shelf24 × 1224 × 11 5/815 7/8 × 23 3/42 · Shelf24 × 122 · Shelf24 × 122 · Shelf24 × 1224 × 11 5/831 3/4 × 4896 in48 in
Sheet cutting (2D): straight through cuts along the length and the width.

The rule of thumb for boards

SituationMode
Board is only shortened, width stays1D – linear
Board is also ripped narrower2D – sheets
Different cross sections (e.g. 2×4 and 2×6)1D, separate material groups
Sheets of different thickness2D, separate material groups

Keep material groups separate

Parts are only assigned to stock of the same material group. Create one group per combination of material and thickness or profile. A 1/2 in back panel never lands on a 3/4 in sheet, even if the dimensions would fit.

What neither mode calculates

  • Free contours, curves and nesting of shaped parts
  • Mitre and bevel cuts
  • CNC toolpaths or machine control
  • Edge banding deductions; enter parts at their actual cutting size

Start planning