Example · Sheet cutting
Two-door wardrobe
A 6 ft tall, 30 in wide wardrobe with two doors and three shelves from two plywood sheets. Long parts such as the sides and doors drive the layout here.
Open and edit in the plannerFree · No sign-up needed · Your data stays with you
Result
- 9 / 9 Parts placed
- 2 Stock pieces
- 16 cuts
- 71.8 % Material use
- 0.59 ft² Saw loss
- 28 1/2 × 18 in largest offcut
✓ Geometry independently validated
Your stock
- Plywood sheet 4×8: 2 × 96 × 48 in · Available stock
Parts to cut
- Side: 2 × 72 × 16 in
- Top and bottom: 2 × 28 1/2 × 16 in
- Shelf: 3 × 28 1/2 × 15 in
- Door: 2 × 71 3/4 × 14 3/4 in
Rules
- Material group: Plywood · 3/4 in
- Saw kerf: 1/8 in
- Edge trim: 0 in
- Grain axis: No constraint
- Allow 90° rotation: yes
Cutting sequence · Stock piece 1
- Piece 96 × 48 in: vertical cut 72 in from the left edge. Leaves 72 × 48 in and 23 7/8 × 48 in; kerf 1/8 in.
- Piece 72 × 48 in: horizontal cut 16 in from the top edge. Leaves 72 × 16 in and 72 × 31 7/8 in; kerf 1/8 in.
- Piece 72 × 31 7/8 in: horizontal cut 16 in from the top edge. Leaves 72 × 16 in and 72 × 15 3/4 in; kerf 1/8 in.
- Piece 72 × 15 3/4 in: vertical cut 71 3/4 in from the left edge. Leaves 71 3/4 × 15 3/4 in and 1/8 × 15 3/4 in; kerf 1/8 in.
- Piece 71 3/4 × 15 3/4 in: horizontal cut 14 3/4 in from the top edge. Leaves 71 3/4 × 14 3/4 in and 71 3/4 × 7/8 in; kerf 1/8 in.
- Piece 23 7/8 × 48 in: vertical cut 16 in from the left edge. Leaves 16 × 48 in and 7 3/4 × 48 in; kerf 1/8 in.
- Piece 16 × 48 in: horizontal cut 28 1/2 in from the top edge. Leaves 16 × 28 1/2 in and 16 × 19 3/8 in; kerf 1/8 in.