Help
How CuttingFox calculates and checks every plan
A cutting plan is only useful if you can trust it. Here is how CuttingFox calculates, what every plan goes through before you see it, and where the limits are.
In short: CuttingFox calculates in your browser with several fixed strategies and picks the plan in a fixed order: all parts first, then little purchased and new stock, then few cuts. Every plan is checked independently for sizes, overlaps, kerfs and the material balance before you see it. CuttingFox does not promise a proven optimum.
Updated November 15, 2026 · CuttingFox team
CuttingFox does the math for you: enter your sizes and get a cutting plan, free and with no sign-up.Start planning →
The calculation runs in your browser
The calculation runs on your device, in a separate background process of the browser. Your dimensions are not sent to a server for it. The same input always gives the same plan: there is no randomness and no time limit that could give a different result on a slower device.
Only cuts you can make at the saw
Every cut runs straight and all the way through the current piece and splits it into two rectangles (a guillotine cut). Plans like this work on a table saw, panel saw, track saw or miter saw. CuttingFox does not plan free nesting, curves or miters.
Several strategies, one fixed comparison
- The planner lays out the parts with several fixed strategies: sorted by area, length, width or longest side, each with vertical or horizontal first cuts.
- In linear mode, another strategy fills board after board with the combination of pieces that leaves the least waste. For up to 10 pieces, the planner also searches every assignment, with a fixed limit on the number of steps.
- Among all results, the plan wins in a fixed order: as many parts placed as possible, as little purchased stock as possible, as little new stock as possible (existing offcuts do not count), then the total amount of stock and the number of cuts.
- With the goal “Fewest cuts, may use more material”, cuts count before stock; with “Keep the largest possible offcut”, the largest offcut counts before the number of cuts.
- If you chose rip or crosscut under “First cut on each sheet”, every sheet starts with a cut in that direction; the strategies then only vary the cuts after it. The independent check verifies this setting too.
Exact dimensions and kerf
- Internally, CuttingFox works in whole hundredths of a millimeter. Every input is rounded exactly once, inch fractions included; after that, no rounding errors build up.
- Kerf only counts for separating cuts that are actually made. A part exactly as long as the stock loses nothing. If less than one kerf remains after a cut, only the material that is really there counts as loss.
- An edge trim you set is taken off before any other cut.
Every plan is checked independently
Before a plan appears, a separate checker tests it, independent of the calculation: once right after it and again before display. If a check fails, the planner shows an error instead of a plan. Among other things, it checks:
- Every part lies completely on the stock and overlaps no other part.
- Every part has exactly the size you entered; it is rotated only if rotation is allowed and the grain direction fits.
- Every part appears exactly once in the result, either placed or listed as missing with a reason.
- Every kerf has the width you set, and no part lies on stock from another material group.
- The balance adds up: parts, kerfs, edge trim and offcuts together make up exactly the stock used.
- Purchased pieces appear only when you turned on “Plan additional stock”.
What CuttingFox does not promise
- No proven optimum: the strategies find good plans, but in rare cases they can miss a better combination. A missing part is a strong hint, but no mathematical proof that it cannot fit.
- No fixed savings: how much stock you save depends on your parts and stock sizes.
- You check the dimensions: the plan works with what you enter. Measure your stock and blade before you cut.